Dascom 7010 Programmers Manual ZPL - Manual (Page 9)

9
Accepted Values:-9999 to 9999
Initial Value at Power-up:0
Comments:
When entering positive values, it is not necessary to use the + sign, The value is assumed to be
positive unless preceded by a negative sign.
^PW
Print Width
Description:
The ^PW command allows you set the print width.
This command changes “Label Width”(operation panel).
Format: ^PWa
Parameters:
a = label width in dots
Default Values:
A value must be entered or the command is ignored
103.9mm(4.09) inches using 8 dot/mm printhead
Comments:
^FW
Field Orientation
Description:
The ^FW command sets the default orientation for all command fields that have an orientation
(rotation) parameter. Fields can be rotated 0,90,180,270 degrees clockwise by using this command.
The ^FW command only affects fields that follow it. Once you have issued a ~FW commands, the
setting is retained until you turn off the printer or send a new ^FW command to the printer.
Format: ^FWr
Parameters:
r = rotate field
Accepted Value:
N = normal
R = rotated 90 degrees
I = inverted 180 degrees