Dascom 7010 Programmers Manual ZPL - Manual (Page 25)

25
^CW
Font Identifier
Description:
All built-in fonts have a one-character identifier. The ^CW command assigns a single alphanumeric
character(A through Z and 0 to 9)to a font stored in DRAM, memory card, EPROM or Flash.
IF the assigned character is the same as that of a built-in font, the downloaded font is used in place
of the built-in font. The new font will be printed on the label wherever the format calls for the
built-in font. If used in place of a built-in font, the change is only in effect until power is turned off.
If the assigned character is different, the downloaded font is used as an additional font. The
assignment will remain in effect until a new command is issued or the printer turned off.
Format:^CWa,d:o,x
Parameters:
a = letter of existing font to be substituted, or new font to be added
Required is a one-character entry.
d = destination of device to store font in(optional)
Accepted Values: E:, B:, R:, Z:
Default :R:
o = name of the downloaded font to be substituted for the built-in, or as an additional font(1
to 8 alphanumeric characters)
Accepted Values: any name up to 8 characters
Default: If no name is entered, UNKNOWN is used.
x = 3-character extension
Fixed: .FNT
Example:
To use MYFONT.FNT stored in DRAM whenever a format calls for Font A:
^XA^CWA,R:MYFONT.FNT^XZ
To use MYFONT.FNT stored in DRAM as additional Font Q:
^XA^XWQ,R:MYFONT.FNT^XZ
To use NEWFONT.FNT stored in DRAM whenever a format calls for font F:
^XA^CWF,R:NEWFONT.FNT^XZ