Dascom 7010 Programmers Manual ZPL - Manual (Page 21)

21
Accepted Values: Multiples of height from 1 to 24 times the standard height,in
increments of 1.
Default Value: The standard matrix height for a specified font.
w = width(in dots)
Scalable:
Accepted Values:10 to 1500
Default Value: last accepted value for ^CF.
Bitmapped:
Accepted Values: Multiples of width from 1 to 24 times the standard width, in
increments of 1.
Default Value: The standard matrix width for a specified font.
Comments:
Fonts are built using a matrix that defines standard height-to-width ratios. If you specify only the
height or width value, the standard matrix for that font will automatically determine the other value.
If the value is blank or a 0(zero) is entered, the height or width will be determined by the standard
font matrix.
^A@
Use Font Name to Call Font
Description:
The ^A@ command uses the complete name of a font, rather than the character designation used in
^A. Once ^A@ is defined, it will represent that font until a new font name is specified by ^A@.
Format: ^[email protected],w,n
Parameters:
o = font orientation
Accepted Values:
N = normal
R = rotated90 degrees(clockwise)
I = inverted180 degrees
B = read from bottom up,270 degrees
Default Value: Last ^FW value or N if an orientation is not specified.
h = character height(in dots)
Default Value: Magnification specified by w(character width)or the last accepted ^CF