Dascom 7010 Programmers Manual ZPL - Manual (Page 17)

17
Assume the current value is 15.An ^MD-6 command is received that changes the current value to
9.Another command,^MD2,is received. The current value is changed 17.The two ^MD commands
were treated individually with respect to the current value of 15.
~SD
Set Darkness
Description:
The ~SD command lets you set the darkness of printing via ZPL®. It is equivalent to the darkness
setting parameter on the front panel display.
This command changes “Print Darkness”(operation panel).
Format: ~SD#
Parameters:
#=desired darkness setting(2-digit number)
Accepted Values:00 to 30
Default Value: last permanently saved value
Comments:
The ^MD command value, if applicable, is added to the ~SD command.
Text for Labels
^CI
Change International Font
Description:
The printers can print TrueType fonts using various international character sets; USA, UK,
Denmark/Norway, Sweden/Finland, Germany, France, Italy, and Spain.
ZPL® follows the ISO standards for international characters.
The ^CI command enables you to call up the international character set you want to use for printing.
You can mix character sets on a label. The following page shows the international character sets
available.
This command allows character remapping. Any character within a font can be remapped to a
different numerical position.