Dascom 7010 Programmers Manual ZPL - Manual (Page 62)

62
Printing Mirror Image of Label
Description:
The ^PM command prints the entire printable area of the label as a mirror image. This command
flips the image from left to right.
Format: ^PMa
Parameters:
a = print mirror image of entire label
Accepted Values: Y(yes) or N(no)
Default Value: N
Comments:
If the parameter is missing or invalid, the command will be ignored. Once entered, the ^PM
command will remain active until ^PMN is received or the printer is powered down.
^SN
Serialization Data
Description:
The ^SN command allows the printer to index data fields by a selected increment or decrement
value(i.e., make the data fields increase or decrease by a specified value)each time a label is printed.
This can be performed on up to 100 to 150 fields in a given format and can be performed on both
alphanumeric and bar code fields. A maximum of 12 of the rightmost integers are subject to indexing.
The first integer found when scanning from right to left starts the indexing portion of the data field.
If the alphanumeric field to be indexed ends with an alpha character, the data will be scanned,
character-by character, from right to left until a numeric character is encountered. Serialization will
take place using the value of the first number found.
Format: ^SNv,n,z
Parameters:
v = starting value
Accepted Values: up to 12 digits for the portion to be indexed.
Default Value:1
n = increment/decrement value
Accepted Values:12-digit maximum
Default Value:1