Dascom 7010 Programmers Manual ZPL - Manual (Page 63)

63
To indicate a decrement value, precede the value with a minus sign(-).
z = add leading zeros(if needed)
Accepted Values: Y(yes) or N(no)
Default Value: N
Comments:
Incrementing and decrementing takes place for each serial-numbered field when all replicates for
each serial number have been printed, as specified in parameter r of the ^PQ(print quality)command.
If, during the course of printing serialized labels the printer runs out of either paper or ribbon, the
first label printed(after the media or ribbon has been replaced and calibration completed)will have
the same serial number as the “partial” label printed before the “out” condition occurred. This is
done in case the last label before the “out” condition did not fully print.
~TA
Tear-off Adjust Position
Description:
The ~TA command lets you adjust the rest position of the media after a label is printed, which
changes the position at which the label is torn or cut.
Format: ~TA###
Parameters:
### = change in media rest position(3-digit value in dot rows)
Accepted Values:-120 to 120
Default Value: last permanent value saved
Comments:
If the parameter is missing or invalid, the command is ignored.
~EF
Erase Stored Formats
Description:
The ~EF command erases all stored formats.
Format:~EF
Comments: