Dascom 7010 Programmers Manual ZPL - Manual (Page 7)

7
with preprinted labels, use this command to move the reference point below the preprinted area.
This command will only affect fields that come after it. It is suggested that this be one of the first
commands in the label format.
Format: ^LHx,y
Parameters:
x = x-axis position(in dots)
Accepted Values: 0 to 7999(200dpi) / 0 to 11998(300dpi)
Initial Value at Power-up:0 or last permanent saved value
y = y-axis position(in dots)
Accepted Values: 0 to 7999(200dpi) / 0 to 11998(300dpi)
Initial Value at Power-up:0 or last permanent saved value
Depending on the printhead used in your printer, use one of the following when figuring the values
for x and y:
8 dots=1 mm(millimeter),200 dots=1 inch.
12 dots=1 mm(millimeter),300 dots=1 inch.
To be compatible with existing printers, this command must come before the first ^FS(Field
Separator)command. Once you have issued an ^LH command, the setting is retained until you turn
off the printer or send a new ^LH command to the printer.
^LL
Label Length
Description:
The ^LL command defines the length of the label. This command is necessary when using
continuous media(i.e. media not divided into separate labels by gaps, spaces, notches, slots or holes).
To affect the current label and be compatible with existing printers, this command must come before
the first ^FS command. Once you have issued an ^LL command, the setting is retained until you turn
off the printer or send a new ^LL command to the printer.
This command changes “Contitu.MediaLen”(operation panel).
Format: ^LLy
Parameters:
y = y-axis position(in dots)
Accepted Values: 1 to 7999(200dpi) / 1 to 11998(300dpi),not to exceed the maximum
label size.
While the printer will accept any value for this parameter, the amount of memory