Dascom 7010 Programmers Manual ZPL - Manual (Page 69)

69
The ^PR command determines the midia speed during printing and the slew speed(feeding a blank
label).
The printer will operate with the selected speeds until the setting is reissued or the printer is turned
off.
The print speed is application-specific. Since print quality is affected by media and ribbon, printing
speeds and printer operatin g modes, it is very imorttant to run tests for your applications.
Format: ^PRp,s,b
Parameters:
p = print speed
Accepted Values:
A or 2 50.8 mm/sec. (2 inches/sec.)
B or 3 76.2 mm/sec. (3 inches/sec.)
C or 4 101.6 mm/sec. (4 inches/sec.)
5 127 mm/sec. (5 inches/sec.)
D or 6 152.4 mm/sec. (6 inches/sec.)
E or 8 203.2 mm/sec. (8 inches/sec.)
9 220.5 mm/sec.(9 inches/sec.)
10 245 mm/sec. (10 inches/sec.)
11 269.5 mm/sec. (11 inches/sec.)
12 304.8 mm/sec. (12 inches/sec.)
Default Value: A
s = slew speed
Accepted Values:
A or 2 50.8 mm/sec. (2 inches/sec.)
B or 3 76.2 mm/sec. (3 inches/sec.)
C or 4 101.6 mm/sec. (4 inches/sec.)
5 127 mm/sec. (5 inches/sec.)
D or 6 152.4 mm/sec. (6 inches/sec.)
E or 8 203.2 mm/sec. (8 inches/sec.)
9 220.5 mm/sec.(9 inches/sec.)
10 245 mm/sec. (10 inches/sec.)
11 269.5 mm/sec. (11 inches/sec.)
12 304.8 mm/sec. (12 inches/sec.)
Default Value:D
b = backfeed speed