Dascom 7010 Programmers Manual ZPL - Manual (Page 71)

71
This command lowers the density of the print – ,12 dots/mm would become 6 dots/mm,8 dots/mm
would become 4.
This command must be entered before the first ^FS command. The effects of ^JM are persistent.
Format: ^JMn
Parameters:
n = set dots per millimeter
Accepted Values:
A = 12 dots/mm,8 dots/mm
B = 6 dots/mm, 4 dots/mm
Default Value: A
Comments:
If ^JMB is used, the UPS Maxicode bar code becomes out of specification.
^CC ~CC
Change Caret
Description:
The ^CC and ~CC commands are used to change the format command prefix. The default prefix is
the caret(^)
Format: ^CCx or ~CCx
Parameters:
x = caret character change
Accepted Values: any ASCII character
Default Value: a parameter is required. If no parameter is entered, the next character
received will be the new prefix character.
Example:
^XA
^CC/
/XZ
Comments:
In the above example, the forward slash(/) is set at the new prefix. Note the /XZ ending tag uses the
new designated prefix character(/).