Dakota Ultrasonics MINI--MAX User Manual

Page 37

MINI-MAX Ultrasonic Bolt Tension Monitor

This feature will prove to be very valuable, avoiding the tedious process of
manually trying to locate the detection point.

2. High Speed Update – Activates the high speed update mode, when using

Dakota’s special shut-off box, installed and connected to a pump. This
feature can only be activated while measuring quantities other than the
reference lengths, and should only be activated if connected to the shut-
off box.

4.19 ON/OFF Key

The ON/OFF key simply powers the unit either ON or OFF. Note: Unit will
automatically power off when idle for 5 minutes. All current settings are saved
prior to powering off.

4.20 Top & Bottom End Caps

The top & bottom end panels are where all connections are made to the MINI-
MAX. The diagram above shows the layout and description of the connectors:

Transducer Connector

Refer to Diagram: The transducer connector, temperature sensor (option), and
battery cover/probe zero disk are located on the MINI-MAX’s top end cap. The
transducer connector is of type Lemo “00”, and the temperature sensor
connector is of type Lemo 1 5 pin.