Barco CLM HD8 R9050130 - Manual (Page 30)

3. Physical installation
Image 3-13
Mount rigging points
The cover plate will move down while pushing with the head but comes back to its position once the bolt is in the slot.
2. Slide a washer on the bolt and turn on a nut.
3. Measure the distance, center tube as reference, between the two used support bars of the truss.
X mm
Image 3-14
4. Slide the rigging points on there place in the slots, according the measured distance and secure this position by fastening the
nut completely. Ensure that the rigging points are symmetrically lined up, so that the projector will hang in balance. If necessary
move point B from a transversal position to a longitudinal position.
Warning: Always secure the rigging points after adjustment.
x mm
A
B
Image 3-15
Set up truss width
5. Turn the rigging clamps on the bolts.
26 R59770057 CLM HD8 15/03/2010