Barco CLM HD8 R9050130 - Manual (Page 29)

3. Physical installation
When this is achieved, the projector is set horizontal and vertical at right angles to the screen.
SCRE
EN
SCR
EEN
Image 3-11
3.4 Suspension of the CLM projector with rigging clamps
Before the projector can be suspended, the optional carry handle must be mounted on the projector. For more
information about the optional carry handle, see "Mounting optional Carry handle", page 211.
C
AUTION
:
Consult a professional structural engineer to ensure that the suspension system is suitable for
this task.
Rigging points and rigging clamps
The carry handle is provided with six slots. Four slots are longitudinally oriented (A) and two slots are transversely oriented (B). In
each slot, a rigging point can be inserted (this rigging point is mounted on the clamps) and the position in the slot can be adjusted
depending of the size of the truss installation. The rigging clamps turn in these rigging points and these clamps allow an easy and
fast physical setup of the projector in a hanging configuration.
A
A
B
C
Image 3-12
Rigging slots and clamps
Necessary tools
Open end spanner 17 mm
Necessary parts
• Four rigging clamps (R855943)
• Safety cable (B361213)
• Two snap hook locks (B361212)
Mounting the rigging points into the handle
1. Push the cup square neck bolt through the slot input and slide the bolt into the slot.
Note: Take the bolt by its thread so that it does not fall inside the carry handle.
R59770057 CLM HD8 15/03/2010 25