Barco CLM HD8 R9050130 - Manual (Page 173)

16. Servicing
16. SERVICING
About this chapter
This chapter contains general servicing procedures like lamp replacement, input unit replacement etc. Note that some of these
procedures may only be performed by qualified technical service personnel. These procedure are marked with a warning.
Extra service information
Extra service information for qualified service technicians can be found on Barco’s Partnerzone (URL: www.partner-
zone.events.barco.com ). Registration is necessary.
If you are not yet registered, click on Partnerzone registration and follow the instructions. With the created login and password, it is
possible to enter the partnerzone where you can find extra service information about the projector.
HEPA
High Efficiency Particulate Absorbing
Overview
• Replacement of the dust filter on the top side
• Replacement of the dust filters on the front side
• Lens installation
• Lens removal
• Removal of a lamp unit
• Mounting a new lamp unit
• Removal of an input module
• Inserting an input module
• Top-up the reservoir with cooling liquid
C AUTION : All HEPA filters of the projector must be replaced on a regular basis, depending on the environment
conditions of the projector.
16.1 Replacement of the dust filter on the top side
All dust filters in the projector are identical.
Necessary parts
New HEPA dust filter.
How to replace the filter on top of the projector
1. Switch off the projector and unplug the power cord from the wall outlet.
2. Remove the lamp door, see "Removal of the lamp door", page 182.
3. Take the filter on the side parallel with the cover and pull it upwards (A). Pivot it a little and take it out (B).
R59770057 CLM HD8 15/03/2010 169