AMX Modero NXD/NXT-1200VG - Manual (Page 69)

Installation Procedures: 12" and 15" Panels
55 VG-Series Modero Touch Panels
Installing the NXD into a Flat Surface using #4 screws
Mounting screws (#4, not included) are secured through circular holes located at the left and right sides of the
NXD panel. The most important thing to remember when mounting the NXD is that the outer frame
(Mounting Tabs) must be installed flush against the mounting surface.
 It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
1. Prepare the area by removing any screws or nails from the surface before beginning the cutout process.
2. Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 43 and for the 15-
inch Wall Mount using the dimensions shown in FIG. 44.
3. Remove the magnetic faceplate/bezel (A in FIG. 45) from the main NXD unit (B in FIG. 45) by gripping
the faceplate and pulling with gentle outward force.
FIG. 43 NXD 12-inch Wall Mount panel dimensions using #4 mounting screws
FRONT BEZEL
SECURE UNIT WITH #4 SCREWS.
SURFACE (PODIUM, DESK, ETC.).
WHEN MOUNTING UNIT TO A SOLID
THESE 4 HOLES ARE ONLY REQUIRED
CUTOUT