AMX Modero NXD/NXT-1200VG - Manual (Page 158)

Firmware Pages and Descriptions
144 VG-Series Modero Touch Panels
Protected Setup Page Elements (Cont.)
Keyboard Layout: Displays the listing of supported international keyboard settings. The following
list allows the end-user to specify which international keyboard is being
connected to the Modero touch panel and then which characters should be
reflected within the G4 Computer Control and TakeNote applications:
- None (default), Spanish, Italian, French, German, Swiss, UK, and US
Note: You must be using a standard 101 button keyboard to accurately
utilize this feature.
• Modero uses the open-source VNC character standards to transmit the
character information to a target device such as a PC.
• One of the issues which occurred in the past was that some 101-key foreign
keyboard character sets were being incorrectly represented via the Computer
Control and Take Note applications.
• For example: Spanish keyboards consisting of Castilian character sets such
as tilde ( é) were being miscommunicated by the VNC application to the
source computer and as a result, passwords were not properly being entered.
• The VNC - Computer Control keyboard drivers found in earlier Modero
firmware (build 57 or earlier) were using an English type/character set which
was not fully utilizing all available foreign characters.
• Several different countries have produced 101-key international keyboards,
each with their own unique set of keys occupying the keyboard. Several of
these keys are specific to the language they are used with.
Options: Allows you to select various touch panel features:
• The Function Show button enables the display of the channel port and
channel code in the top left corner of the button, the level port and level code
in the bottom left corner, and the address port and address code in the
bottom right corner (see FIG. 118 for an example of the function locations).
• Use the Page Tracking button to toggle page tracking. When enabled, the
touch panel sends page data back to the NetLinx Master, or vice versa
depending on the touch panel settings.
• Use the Telnet button to enable or disable the telnet server on the panel. This
feature focuses on direct telnet communication to the panel.
• Use the Front Button Setup Access button to activate the grey Front Setup
Access button (located below the LCD) to access the firmware pages.
- Default condition is On.
- Press and hold this grey button for 3 seconds to access the Setup page.
- Press and hold this grey button for 6 seconds to access the Calibration
page.
• Use the Security button to toggle between three security settings: Standard
Security, Secure, and DoD. Refer to the Security Settings section on
page 145 for very important information on using this feature.