AMX Modero NXD/NXT-1200VG - Manual (Page 49)

Touch Panel Accessories
35 VG-Series Modero Touch Panels
Step 4: Install the Compact Flash Memory Card upgrade
1. Discharge any static electricity from your body by touching a grounded metal object and then locate the
existing Compact Flash card (factory-shipped with 128 MB) on the main board (FIG. 20 for Table Top
panels and FIG. 23 for Wall Mount panels).
2. Insert the tip of a grounded flathead screwdriver into one of the card removal grooves (located on either
side of the card), and gently pry the card out of the slot (FIG. 21). Repeat this process on the opposite card
removal groove. This alternating action causes the card to "wiggle" away from the
on-board connector pins.
3. Grip the old card by its sides and then carefully pull it out of the slot.
4. Remove the new CF memory card from it’s anti-static bag.
5. Grip the sides of the new CF memory card and firmly insert it into the slot opening (with the arrow facing
towards the pins) until the contact pins are completely inside the flash card and it is then securely attached
to the pin sockets.
FIG. 20 Location of the Compact Flash card and I/O plate on NXT
FIG. 21 Removing/installing a Compact Flash Memory card
I/O connector
Compact Flash card
Outer Housing
plate
Eight Housing
Screws
NXA-PCI80211G
wireless card
location
Card removal
grooves
Insert with arrow
facing towards the pins
On-board Compact
Flash connector (with pins)
Connector opening