AMX Modero NXD/NXT-1200VG - Manual (Page 207)

Programming
193 VG-Series Modero Touch Panels
"^" Button Commands (Cont.)
^BMF (Cont.) ’%F’, = Set the font. See theDefault Font Styles and ID
Numbers table on page 186.
’%F’ = Set the font. See theDefault Font Styles and ID
Numbers table on page 186.
’%MI’ = Set the mask image. Refer to the ^BMI command on page 195 for
more information.
’%T’ = Set the text using ASCII characters (empty is clear).
’%P’ = Set the picture/bitmap filename (empty is clear).
’%I’,’ = Set the icon using values of 01 - 9900 (icon numbers are
assigned in the TPDesign4 Resource Manager tab - Slots section).
’%I’ = Set the icon using values of 01 - 9900 (icon numbers are
assigned in the TPDesign4 Resource Manager tab - Slots section).
’%J’, = As shown the following telephone keypad alignment
chart:
’%JT’ = As shown the above telephone keypad alignment chart,
BUT the 0 (zero) is absolute and followed by ’,,’
’%JB’ = As shown the above telephone keypad
alignment chart BUT the 0 (zero) is absolute and followed by ’,,’
’%JI’ = As shown the above telephone keypad alignment chart,
BUT the 0 (zero) is absolute and followed by ’,,’
For some of these commands and values, refer to theRGB Values for all 88 Basic
Colors table on page 184.
’%CF’ = Set Fill Color.
’%CB’ = Set Border Color.
’%CT’ = Set Text Color.
’%SW<1 or 0>’ = Show/hide a button.
’%SO’ = Set the button sound.
’%EN<1 or 0>’ = Enable/disable a button.
’%WW<1 or 0>’ = Word wrap On/Off.
’%GH’ = Set the bargraph upper limit.
’%GL’ = Set the bargraph lower limit.
’%GN’ = Set the bargraph slider name/Joystick cursor name.
’%GC’ = Sets the bargraph slider color/Joystick cursor color.
’%GI’ = Set the bargraph invert/noninvert or joystick coordinate
(0,1,2,3). ^GIV section on page 201 more information.
’%GU’ = Set the bargraph ramp up time in intervals of 1/10 second.
’%GD’ = Set the bargraph ramp down time in 1/10 second.
’%GG = Set the bargraph drag increment. Refer to the ^GDI
command on page 200 for more information.
’%VI’ = Set the Video either On (value=1) or Off (value=0).
’%OT’ = Set the Feedback (Output) Type to one of the following:
None, Channel,Invert, On (AlwaysOn), Momentary, or Blink.
’%SM’ = Submit a text for text area button.
’%SF<1 or 0>’ = Set the focus for text area button.
’%OP<0-255>’ = Set the button opacity to either Invisible (value=0) or Opaque
(value=255).
’%OP#<00-FF>’ = Set the button opacity to either Invisible (value=00) or Opaque
(value=FF).
’%UN’ = Set the Unicode text. See the^UNI section on page 206 for the
text format.
1
4
7 8 9
6
3 2
5
0
Zero can be used for an absolute position