AMX Modero NXD/NXT-1200VG - Manual (Page 217)

Programming
203 VG-Series Modero Touch Panels
"^" Button Commands (Cont.)
^JST
Set text
alignment using a
numeric keypad
layout for those
buttons with a
defined address
range.
The alignment of 0 is followed by ',,'. The left and top coordinates are relative
to the upper left corner of the button.
Syntax:
"'^JST-,,alignment>'"Variable: variable text address range = 1 - 4000.button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).new text alignment = Value of 1 - 9 corresponds to the following locations: Example:SEND_COMMAND Panel,"'^JST-500.504&510.515,1&2,1'"Sets the text alignment to the upper left corner for those buttons with variable text ranges
of 500-504 & 510-515.^MBTSet the Mouse
Button mode On
for the virtual PC.Syntax:"'^MBT-'"Variable: pass data:0 = None1 = Left2 = Right3 = MiddleExample:SEND COMMAND Panel,"'^MBT-1'"Sets the mouse button mode to ’Left Mouse Click’.^MDCTurn On the
’Mouse
double-click’
feature for the
virtual PC.Syntax:"'^MDC'"Example:SEND COMMAND Panel,"'^MDC'"Sets the mouse double-click for use with the virtual PC.^SAVSave
configuration val-
uesSaves the current configuration values.^SHOShow or hide a
button with a set
variable text
range.Syntax: "'^SHO-,'"Variable: variable text address range = 1 - 4000.command value = (0= hide, 1= show).Example:SEND_COMMAND Panel,"'^SHO-500.504&510.515,0'"Hides buttons with variable text address range 500-504 & 510-515.1478963250Zero can be used for an absolute position
alignment>'"
Variable:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
new text alignment = Value of 1 - 9 corresponds to the following locations:
Example:
SEND_COMMAND Panel,"'^JST-500.504&510.515,1&2,1'"
Sets the text alignment to the upper left corner for those buttons with variable text ranges
of 500-504 & 510-515.
^MBT
Set the Mouse
Button mode On
for the virtual PC.
Syntax:
"'^MBT-'"
Variable:
pass data:
0 = None
1 = Left
2 = Right
3 = Middle
Example:
SEND COMMAND Panel,"'^MBT-1'"
Sets the mouse button mode to ’Left Mouse Click’.
^MDC
Turn On the
’Mouse
double-click’
feature for the
virtual PC.
Syntax:
"'^MDC'"
Example:
SEND COMMAND Panel,"'^MDC'"
Sets the mouse double-click for use with the virtual PC.
^SAV
Save
configuration val-
ues
Saves the current configuration values.
^SHO
Show or hide a
button with a set
variable text
range.
Syntax:
"'^SHO-,'"
Variable:
variable text address range = 1 - 4000.
command value = (0= hide, 1= show).
Example:
SEND_COMMAND Panel,"'^SHO-500.504&510.515,0'"
Hides buttons with variable text address range 500-504 & 510-515.
1
4
7 8 9
6
3 2
5
0
Zero can be used for an absolute position