AMX Modero NXD/NXT-1200VG - Manual (Page 190)

Displaying Stream Content
176 VG-Series Modero Touch Panels
10. Click the States tab of the Button Properties Control window to show a list of all states associated with
the selected button. Each state represented in the States tab is a collapsed folder containing the state
properties for that particular state (On/Off/All).
11. Double-click the All States + symbol to expand this folder (FIG. 139) and locate the Video Fill field.
12. Use the Video Fill drop-down arrow to select the Streaming Video option (A in FIG. 139).
13. Within the newly added Streaming Source field, enter the Transport Protocol, IP Address of the MAX-
CSE, and Target Video Port (B in FIG. 139).
 When using a UDP Transport Protocol, enter the following into the Streaming Source field: udp://
IP Address of MAX-CSE:Target Video Port set on the UI page.
 Our example uses: udp://192.199.99.99:5000
 Refer to Step 2: Configuring the MAX-CSE for communication section on page 171.
The MAX-CSE is available from either the front LCD (FIG. 140) or from the IP Settings page of
the UI.
 When using an RTP Transport Protocol, determine whether you are using an MPEG-2 or MPEG-4
stream and enter the following into the Streaming Source field:
rtpmpeg#://IP Address of MAX-CSE:Target Video Port
 Although our example doesn’t use RTP, you could enter the following:
for MPEG-2 rtpmpeg2://192.199.99.99:5000
for MPEG-4 rtpmpeg4://192.199.99.99:5000
14. Create buttons on both this project’s main page and within this Video page which can allow the user to
navigate between both pages.
15. Save these pages, and after establishing a connection, upload this project to the target Modero panel.
FIG. 139 Video Fill - Button Properties setting
FIG. 140 Example of the current display
A B
Modero doesn’t require that an audio port be entered within the Streaming Source
field because the firmware already assumes the audio port value to be 2 greater than
the value set for the video port.