AMX Modero NXD/NXT-1200VG - Manual (Page 62)

Installation Procedures: 12" and 15" Panels
48 VG-Series Modero Touch Panels
5. Firmly push the Strain Relief Grommet into the opening (toward the inside) until the rim is securely flush
against the back of the rear plastic cover (FIG. 34).
6. Securely grasp both sides of the NXD panel (with LCD, MB-TP12/15 back box, and attached cables),
rotate the entire unit over, and lie it on a flat level surface.
7. Note the available mounting contact surface area on the rear plastic cover of the MB-TP12 (FIG. 35) and
MB-TP15 (FIG. 36). This area represents the space available for use with a VESA connector plate.
Verify the Strain Relief Grommet is securely closed over the cables and the clip is
facing the correct direction (upwards). The process of securing the strain relief
grommet may require the use of pliers. Also verify the length and location of the
inserted cables. Once the strain relief grommet is closed, it is difficult to re-open.
FIG. 35 MB-TP12 Mounting contact surface area
FIG. 36 MB-TP15 Mounting contact surface area
2.61[66MM]
.80[20MM]
3.55[90MM]
2.52[64MM]
3.23[82MM]
.72[18MM]
4.52[115MM]
3.83[97MM]