AMX Modero NXD/NXT-1200VG - Manual (Page 185)

Displaying Stream Content
171 VG-Series Modero Touch Panels
Setting up a Modero Panel to Receive and Display a Stream
The MAX-CSE must first be prepared to stream to the target Modero panel prior to creating the necessary
TPDesign4 panel pages (later be uploaded to the panel).
Step 1: Obtaining the IP Address of the target panel
1. Press the grey Front Setup Access button for 3 seconds to open the Setup page (FIG. 132).
2. Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup
page and display an on-screen keypad.
3. Enter 1988 into the Keypad’s password field and press Done when finished.
4. Press the System Settings button (located on the Protected Setup page) to open the System Settings page
and obtain the IP information from the IP Address field (FIG. 133).
Step 2: Configuring the MAX-CSE for communication
1. Complete the procedures outlined within the Configuring the MAX Communication Parameters section of
the MAX-CSE Instruction Manual to establish an active connection to the source
MAX-CSE.
2. Confirm the MAX-CSE is properly configured to use the newly established Static IP Address by
launching your browser and entering the MAX’s new Static IP Address into the browser’s Address field.
3. Press the Enter key on your keyboard to initiate the communication process and launch the initial on-
screen Enter Network Password security dialog.
4. Enter the words administrator and password (if using the default login profile) into the corresponding
User Name/Password fields. This is the factory default security login information.
FIG. 132 Setup page
FIG. 133 System Settings page
Connection Status
Red Connection Status icon -
Green Connection Status icon -
indicates no connection to a Master
indicates communication to a Master
Modero
IP Address
information