RADWAG PS 510.R2.CT Carat Balance - Manual (Page 98)

- 98 -
• Place the declared number of pieces in the container and when the
result is stable (the symbol is displayed) and confirm their mass by
pressing button,
• The balance software automatically counts a single sample mass and
enters the mode <COUNTING PIECES> displaying the number of
pieces which are on the pan (pcs). In the bottom line, a single sample
mass value is shown (if the option for the function
<INFORMATION>has been selected).
CAUTION:
It should be remembered that:
•
The total mass of all the pieces put on the weighing pan must not be greater
than the balance’s maximum weighing range.
•
The mass of a single piece cannot be lower than the 0,1 reading unit of the
balance. If this condition is not met, the balance displays the message: low sample mass>.
•
While determining the number of pieces, wait for the stability pictogram ,
in order to confirm the quantity.
•
Only after the stability pictogram is displayed can you confirm the declared
quantity by pressing
button. Otherwise, the balance will not accept the
measurement.
18.2.3. Setting the reference mass by entering its mass
Procedure:
• Press one of the F buttons, to which the function <ENTER SAMPLE>
is assigned, and the editing window <ENTER SAMPLE> is displayed