RADWAG PS 510.R2.CT Carat Balance - Manual (Page 46)

- 46 -
< AUTO THRES. > parameter is connected with the following functions:
-
automatic tare,
-
automatic operation,
For automatic operation function the measurement will not be send from the
computer to the printer as long as the mass measurement stays withing the set
value range < P 2.2.3.2 PROG THRES>.
10.7. Temporary measuring unit
This function is only available for various modes except for
COUNTING> and . In other modes measurements
are only possible in basic unit [g].
Function enables selecting a measuring unit which will be indicated next to
mass reading during the operation. Set measuring unit will be in use from the
moment of its activation until its change or switching off and on the balance.
Each press of the button causes change of the measuring unit.
Available settings:
•
For verified balances, a user can select from the following: [g], [mg] or
[kg], [ct]
• For non-verified balances, a user can select from the following measuring
units: [g], [mg], [kg], [ct], [lb], [oz], [ozt], [dwt], [tlh], [tls], [tlt], [tlc], [mom],
[gr], [ti], [N]