RADWAG PS 510.R2.CT Carat Balance - Manual (Page 45)

- 45 -
printing frame when the result is unstable.
This function applies only to non-verified balances.
• - select this option to enable automatic printing of
measurements. If this option has been selected, remember to select
parameter to suit your needs.
Automatic operation proceeds as follows:
 Press button to zero the balance (marker of stable
measurement and zero marker are shown on display)
 Place the load, the balance sends the first stable measurement to
the printer port,
 Remove the load from the balance,
 Next measurement is possible when the reading on the display is
lower than the set value of < AUTO THRES. > parameter (next
measurement does not require zero value).
This procedure applies to changing settings:
For automatic working mode adjust the threshold value.