RADWAG PS 510.R2.CT Carat Balance - Manual (Page 23)

- 23 -
2. Glass parts should be cleaned using a dry flannel cloth (mild cleanser may
be used if it does not contain any abrasive substances) – for draft shield
disassembly instruction go to the next section of this manual
3. Use a dry flannel cloth in order to clean disassembled parts (mild cleanser
may be used if it does not contain any abrasive substances)
CAUTION:
Cleaning of the weighing pan when assembled may cause damage of the
measuring system of the balance. Hence, it is crucial to remove it from the
balance before cleaning.
In order to clean the glass walls of the draft shield of the XA R2 and AS R2
series balance, it is acceptable to remove the walls of the draft shield following
the below instruction.
Steps for XA.R2 series balance:
1. Twist off and remove the top glass wall safety frame, and slide the top
glass wall out of the slideway
2. Remove the back glass wall.