RADWAG PS 510.R2.CT Carat Balance - Manual (Page 20)

- 20 -
Balance PS
Remove the adhesive tape. Carefully remove the balance from its packaging.
Remove all the elements necessary for correct operation from the accessory
box. Carefully remove the plastic and foil transport protective elements and
gently place the balance in its intended place of use.
Assemble the weighing pan, and other elements according to below schema:
Assembling a balance with reading interval 10mg:
-
remove the adhesive tape
protecting the mass spring on one
of the rubber bumpers (1),
-
assemble the weighing pan (2) on
the rubber bumpers (1),
-
after assembling the balance
components, check whether the
weighing pan is firmly placed on the
rubber bumpers.
Assembling a balance with reading interval 1mg:
-
remove the adhesive tape protecting the
mass spring on one of the rubber bumpers
(1),
-
assemble the weighing pan (2) on the
rubber bumpers (1),
-
assemble the glass anti-draft shield (3)
-
after assembling the balance components,
check whether the weighing pan is firmly
placed on the rubber bumpers.