Kramer Electronics VS-162V User Manual
Page 50
KRAMER: SIMPLE CREATIVE TECHNOLOGY
MENU Commands
46
7. Press the TAKE button again.
The displays show the messages:
MACHINE ADDRESS
changed
current #
x
After a few seconds, The displays show the messages:
SET highest MACHINE ADDRESS
use OUTkey 1-9, 0
current #
x
8. Press an OUT button # 1-9, 0.
The STATUS Display shows the message:
current #
x
Where x is the OUT button # pressed
At this stage, you can enter another highest MACHINE ADDRESS. The unit
may suggest a highest MACHINE ADDRESS for your system. If so, it is
recommended that you use that address.
9. Press the TAKE button again.
The MATRIX display shows the message:
Change highest MACH. ADDR. ?
Press TAKE to confirm
10. Press the TAKE button again.
The MATRIX display shows the message:
HIGHEST MACHINE ADDRESS
Changed
11.4.2 Changing the Large Matrix MACHINE ADDRESS to Standalone
To set the MACHINE ADDRESS:
1. Press the MENU button until you reach the MACHINE ADDRESS
command.
The MATRIX display shows the message:
MACHINE ADDRESS
setting yes -> TAKE, next -> MENU
2. Press the TAKE button.
The displays show the messages:
OUTkey 1: Stand-Alone UNIT
2: Large Matrix
Current
Matrix
1 Indicating that the machine is not set to standalone