Kramer Electronics VS-162V User Manual
Page 49
MENU Commands
45
45
Plan your system according to the chart in
MACHINE ADDRESS, because in a matrix configuration you need to enter
the highest MACHINE ADDRESS as well as the MACHINE ADDRESS.
11.4.1 Changing the Standalone MACHINE ADDRESS to a Large Matrix
To set the MACHINE ADDRESS:
1. Press the MENU button until you reach the MACHINE ADDRESS
command.
The MATRIX display shows the message:
MACHINE ADDRESS
setting yes -> TAKE, next -> MENU
2. Press the TAKE button.
The displays show the messages:
OUTkey 1: Stand-Alone UNIT
2: Large Matrix
Current
Alone
3. Press the OUT button # 2.
The TAKE LED flashes and The displays show the messages:
Change to the LARGE MATRIX?
Press TAKE to confirm
Current
16x16
4. Press the TAKE button again.
The displays show the messages:
READY to set MACHINE ADDRESS
use OUTkey 1-9, 0
Current #
1
5. Enter the MACHINE ADDRESS by pressing an OUT button # 1-9, 0.
The STATUS Display shows the message:
current:
x
Where x is the OUT button # pressed
6. Press the TAKE button again.
The displays show the messages:
READY to change MACH. ADDR.
Press TAKE to confirm
From # 01
to # x
At this stage, you can enter another MACHINE ADDRESS by pressing another
OUT button.
1 Indicating that the machine is not set to the large matrix setting
2 For example, if currently configured for standalone