Festo Контроллеры двигателя SFC-LAC - Manual (Page 96)

4. Control panel (only type SFC−LACI−...−H2)
4−12
Festo GDCP−SFC−LACI−DN−EN en 0812NH
The Positioning" menu includes entries for starting a homing
run or a positioning run.
Note
Carry out the homing run and the positioning runs as
described in the following sections:
Ĉ Homing: sections 5.2.2 to 5.2.4
Ĉ Positioning runs / test runs: section 5.2.9
[Positioning] Description Note
[Homing] Starting a homing run with the set
homing method Setting the parameters: see [Settings]
[Homing paramet.]
[Move posit. set] Starting a defined positioning record
from the position set table ć or ć
for parameterised record chaining:
start of a record chain Parameterising and referencing must
have been completed
[Demo posit. tab] Test of all positioning records in the
position set table (operating mode
Demo mode") Parameterising and referencing must
have been completed.
There must be at least two positioning
records in the memory.
Tab. 4/4: [Positioning] menu
Cancelling a positioning movement
EMERG.
STOP You use
> Error mode EMERG.STOP) Menu
DEMO
STOP With , you can interrupt the Demo
mode" [Demo posit. tab]. The current
positioning record will be executed before the
axis stops. If you restart, the run will begin
with positioning record 1.
Enter
} Positioning
Homing
Move posit. set
Demo posit. tab