5 connection with other sub-d plugs (ip20), Connection with other sub−d plugs (ip20) – Festo Контроллеры двигателя SFC-LAC User Manual

Page 79

3. Installation

3−25

Festo GDCP−SFC−LACI−DN−EN en 0812NH

3.7.5

Connection with other Sub−D plugs (IP20)

If you are using the Festo plug type FBS−SUB−9−WS−CO−K or
Sub−D plugs from other manufacturers, you must replace the
two flat screws by which the field bus plug is fitted in the
SFC−LACI by bolts of type UNC 4−40/M3x5 (supplied).

Note
Note that when using Sub−D plugs from other manufacĆ
turers only IP20 protection is attained.

Note
If both screws or stud bolts are removed simultaneously,
there is a risk that the plug may be pressed into the
SFC−LACI housing with the internal circuit board.

Always leave one of the screws or stud bolts fitted while
changing over.

1. First slacken just one of the mounting screws and

removeĂit.

2. Screw one of the mounting bolts into the vacant tapped

hole and tighten it.
Maximum tightening torque: 0.48 Nm

3. Repeat steps 1 and 2 for the other screw.