Festo Контроллеры двигателя SFC-LAC - Manual (Page 250)

B. Parametrizing via field bus
B−30
Festo GDCP−SFC−LACI−DN−EN en 0812NH
B.4 Reference FHPP Parameters
B.4.1 FHPP parameter groups
Group PNU Description
Device data 100 ... 199 Device identification and device−specific settings, version
numbers, identifier words, etc.
Diagnosis memory 200 ... 299 Memory for diagnostic events: Fault numbers, fault time,
incoming/outgoing event
Process data 300 ... 399 Current setpoint and actual values, local I/Os, status data etc.
Position record
table (= record list) 400 ... 499 A record contains all the setpoint value parameters required
for a positioning procedure
Project data 500 ... 599 Basic project settings. Maximum speed and acceleration,
project zero point offset, etc.
} These parameters form the basis of the position set table
Factor group 600 ... 699 Reserved
Axis data
Electric drives 1 1000 ... 1099 All axis−specific parameters for electric drives. Gear factor,
feed constant, reference parameter, etc.
Axis data
Electric drives 2 1200 ... Enhancements
Tab. B/9: Parameter groups (FHPP)