Allied Telesis AT-S106 - Manual (Page 34)

Chapter 2: Basic Switch Parameters
34
5. To create an entry number, type 1 through 8 in the box next to the
Entry number field. An entry number cannot be duplicated if it already
exists.
This value appears as the Index value in the Administration table at
the bottom of the page.
6. To create a user name, enter a user name in the box next to the User
Name field.
You can enter a value of up to 12 alphanumeric characters including
special characters. See Appendix A, on page 213 for the specific
characters.
7. To add a password for the above user name, enter a password of up
to 12 alphanumeric characters in the box next to the Password field
including special characters. See Appendix A, on page 213 for the
specific characters.
8. To confirm the above password, retype the password in the box next
to the Confirm Password field.
9. Click Add to activate your changes on the switch.
10. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modifying
Administration
Information
To modify the a user name password, do the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select Administration.
The Administration Page is shown in Figure 8 on page 33.
3. Select the user name that you want to change and click modify.
The Modify Administration Page is displayed. See Figure 9.
Figure 9. Modify Administration Page