Allied Telesis AT-S106 - Manual (Page 23)

23
Chapter 2
Basic Switch Parameters
This chapter provides procedures to perform basic switch activities such
as reassigning the IP address, enabling the DHCP Client, configuring new
user names and passwords, and rebooting the system.
This chapter contains the following sections:
ˆ “Configuring an IP Address, Subnet Mask and Gateway Address” on
page 24
ˆ “Setting Up the IP Access List” on page 26
ˆ “Enabling and Disabling the DHCP Client” on page 28
ˆ “Configuring System Management Information” on page 31
ˆ “Configuring System Administration Information” on page 33
ˆ “Setting the User Interface Configuration” on page 36
ˆ “Viewing System Information” on page 37
ˆ “Rebooting a Switch” on page 40
ˆ “Pinging a Remote System” on page 42
ˆ “Returning the AT-S106 Management Software to the Factory Default
Values” on page 44
Note
To permanently save your new settings or any changes to the
configuration file, select Save Configuration to Flash from the main
menu on the left side of the page.