Allied Telesis AT-S106 - Manual (Page 126)

Chapter 10: Bandwidth Control
126
Setting Ingress Rate Limiting
This procedure explains how to set Bandwidth levels and Status for
Ingress Rate Limiting on each port of the AT-GS950/48 Gigabit Ethernet
Smart Switch.
To change the default settings, do the following procedure:
1. From the main menu on the left side of the page, select the Bridge
folder
2. From the Bridge folder, select Bandwidth Control.
3. The Bandwidth Control folder expands.
4. From the Bandwidth Control folder, select Ingress Rate Filtering.
The Ingress Rate Limiting page is displayed. A partial view is shown in
Figure 39.
Figure 39. Ingress Rate Limiting Page
5. To set the Bandwidth field on the AT-GS950/48, enter a number in
the range of 1 - 15625.