Allied Telesis AT-S106 - Manual (Page 108)

Chapter 8: Simple Network Management Protocol (SNMP)
108
Creating a Host Table
Use the following procedure to create a Host Table.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Host Table.
The Host Table Page is displayed. See Figure 33.
Figure 33. Host Table Page
3. To specify an entry number, type a value between 1 and 10 in the
Entry number field.
4. For an SNMP community that you previously defined in the
Community Table page, enter an IP address.
The IP address must be in the xxx.xxx.xxx.xxx format.
5. Select a community name from the pull-down menu next to the
Community Name field.
6. Click Add.
The new host is added to the table.
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.