Allied Telesis AT-S106 - Manual (Page 162)

Chapter 13: Spanning Tree and Rapid Spanning Tree Protocols
162
4. In the Admin/OperEdge column for the port you want to configure,
choose True or False to set whether or not the port will operate as an
edge port.
When you configure this parameter a True designating the port as an
edge port, the port will always be in a forwarding state.
5. In the Admin/OperPtoP column for the port you want to configure,
choose a setting based on the information in Table 5.
6. In the Migration column for the port you want to configure, click
Restart to reset the port.
7. Click Apply.
8. To configure all of the ports to the same settings, in the All row,
configure one, two, or all of the following settings: Admin/OperEdge,
Admin/OperPtoP, and Migration.
9. Click Apply.
10. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Table 5. RSTP Point-to-Point Status
Admin Operation Port Duplex Operation
Auto True Full
False Half
True True Full or Half
False False Full or Half