Allied Telesis AT-S106 - Manual (Page 183)

AT-S106 Management Software Web Browser User’s Guide
183
Configuring a Dial-in User
The procedures in this section describe how to create, delete, and modify
dial-in users. See the following procedures:
ˆ “Add a Dial-in User” on page 183
ˆ “Modify a Dial-in User” on page 183
ˆ “Delete a Dial-in User” on page 184
Add a Dial-in
User
To set up a user’s dial-in access, do the following procedure:
1. From the main menu, select Security > Dial-in User.
The Dial-in User page is displayed. See Figure 57.
Figure 57. Dial-In User Page
2. In the User Name field, type a name for the user.
3. In the Password field, type a password for the user, and re-type the
name in the Confirm Password field.
4. In the Dynamic VLAN field, enter the VID of the VLAN which you will
allow the user to access. If you enter 0, this field will be ignored.
5. Click Add.
6. To permanently save these settings in the configuration file, select
Save Configuration to Flash from the main menu to permanently
save your changes.
Modify a Dial-in
User
To modify the settings for a dial-in user, do the following procedure:
1. From the main menu, select Security > Dial-in User.
The Dial-in User page is shown in Figure 57 on page 183