Allied Telesis AT-S106 - Manual (Page 111)

AT-S106 Management Software Web Browser User’s Guide
111
Enabling or Disabling Traps
To enable or disable a trap for an SNMP community, do the following
procedure:
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Setting.
The Trap Setting Page is displayed. See Figure 34.
Figure 34. Trap Setting Page
3. Type a trap number between 1 and 10 in the Entry number field.
4. Select the SNMP version of the trap by selecting V1 for SNMP version
1 or V2c for SNMP version v2c in the Version field.
5. Enter an IP address, in the xxx.xxx.xxx.xxx format, in the IP Address
field.
6. Enter a previously defined community name in the Community field.
7. Click Add.
A new trap is displayed in the Trap Setting table.
8. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.