Allied Telesis AT-S106 - Manual (Page 125)

AT-S106 Management Software Web Browser User’s Guide
125
5. To enable or disable the DLF field, select Enable or Disable from the
DLF pull-down menu next to the port that you want to change.
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
6. Click Apply.
7. To enable or disable ingress and egress Broadcast packets, select
Enable or Disable from the Broadcast pull-down menu next to the port
that you want to change.
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
8. Click Apply.
9. To enable or disable ingress and egress Multicast packets, select
Enable or Disable from the Multicast pull-down menu next to the port
that you want to change.
The default is Disable. You can use the option next to the ALL row to
set all of the ports to the same setting.
10. Click Apply.
11. To set the Threshold field, use the pull-down menu next to the port
that you want to change. Select Low, Medium, or High which
correspond to the following values:
Low
Specifies 450 to 550 packets per second.
Medium
Specifies 880 to 1,000 packets per second.
High
Specifies 2,200 to 2,500 packets per second.
The default is Low. You can use the option next to the ALL row to set
all of the ports to the same setting.
12. Click Apply.
13. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.