Allied Telesis AT-S106 - Manual (Page 106)

Chapter 8: Simple Network Management Protocol (SNMP)
106
Modifying an SNMP Community
Use the following procedure to modify the access level or a community
name of an SNMP community in the Community Table.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table Page is shown in Figure 32 on page 105.
3. To change the access level of an SNMP community, select the pull-
down menu under the Access column in the Community table for the
community you want to modify.
4. Select Read-Only access or Read-Write access.
5. To change the community name, type over an existing community
name.
Note
You cannot change the index number of an SNMP community.
6. Click Apply.
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.