Allied Telesis AT-S106 - Manual (Page 26)

Chapter 2: Basic Switch Parameters
26
Setting Up the IP Access List
When the IP Access List feature is enabled, remote access to the
management software is restricted to the IP addresses entered into the IP
Access List. It does not restrict the management ping response activity,
only web access to the management software.
Note
By default, the IP Access List feature is disabled.
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
ˆ “Creating an IP Access List” on page 26
ˆ “Deleting an IP Address” on page 27
Note
You cannot modify an existing IP address.
Creating an IP
Access List
To create a list of accessible IP addresses, do the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select IP Access List. The IP Access List
Page is displayed. See Figure 6.
.
Figure 6. IP Access List Page