Allied Telesis AT-S95 CLI - Manual (Page 85)

Configuration and Image File Commands
Page 85
Chapter 6. Configuration and Image File Commands
copy
The copy Privileged EXEC mode command copies files from a source to a destination.
Syntax
copy source-url destination-url
Parameters
•
source-url — The source file location URL or reserved keyword of the source file to be copied.
(Range: 1 - 160 characters)
• destination-url — The destination file URL or reserved keyword of the destination file.
(Range: 1 - 160 characters)
The following table displays keywords and URL prefixes:
Keyword Source or Destination
flash: Source or destination URL for flash memory. It’s the default in case a URL is specified
without a prefix.
flash://startup-
config Source is the startup-config file in flash memory.
flash://image Source is an image file on flash memory.
running-config Represents the current running configuration file.
startup-config Represents the startup configuration file.
image If the source file, represents the active image file. If the destination file, represents the
non-active image file.
boot Boot file.
tftp:// Source or destination URL for a TFTP network server. The syntax for this alias is tftp://
host/[directory]/filename. The host can be IPv4 address, IPv6 address or hostname.
xmodem: Source for the file from a serial connection that uses the Xmodem protocol.
logging Copy from a syslog file.
unit://member/
image Image file on one of the units. To copy from the master to all units, specify * in the member
field.
unit://member/
boot Boot file on one of the units. To copy from the master to all units, specify * in the member
field.
null: Null destination for copies or files. A remote file can be copied to null to determine its size.
backup-config Represents the backup configuration file.
unit://member/
backup-config Backup configuration on one of the units.