Allied Telesis AT-S95 CLI - Manual (Page 216)

Page 216
Allied Telesis
AT-S95 Management Software CLI User’s Guide
User Guidelines
If the port is trusted, the default CoS value of the port is used to assign a CoS value to all untagged packets
entering the port.
Example
The following example configures port 1/e16 default CoS value to 3.
show qos map
The show qos map User EXEC mode command displays all QoS maps.
Syntax
show qos map [dscp-queue]
Parameters
•
dscp-queue — Indicates the DSCP to queue map.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the DSCP port-queue map.
console(config)# interface ethernet 1/e16
console(config-if) qos cos 3
console> show qos map
Dscp-queue map:
d1 : d2 0 1 2 3 4 5 6 7 8 9
-- : -- -- -- -- -- -- -- -- -- -- --
0 : 01 01 01 01 01 01 01 01 01 01
1 : 01 01 01 01 01 01 02 02 02 02
2 : 02 02 02 02 02 02 02 02 02 02
3 : 02 02 03 03 03 03 03 03 03 03
4 : 03 03 03 03 03 03 03 03 04 04
5 : 04 04 04 04 04 04 04 04 04 04
6 : 04 04 04 04