Allied Telesis AT-S95 CLI - Manual (Page 321)

System Management Commands
Page 321
stack reload
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The stack reload Privileged EXEC mode command reloads stack members.
Syntax
stack reload [unit unit]
Parameters
•
unit — Number of the unit to be reloaded (Range: 1 - 6)
Default Configuration
All units are reloaded.
Command Modes
Privileged EXEC mode
User Guidelines
This command is not relevant to standalone devices.
If no unit is specified, all units are reloaded.
Example
The following example reloads Unit 2 of the stack.
stack change unit-id
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The stack change unit-id Global Configuration mode command is used to change the Unit ID of a specific unit.
Syntax
stack change unit-id unit-number to new-unit-number
Parameters
•
unit-number — Specifies the current number of the unit. (Range: 1 - 6)
• new-unit-number — Specifies the new number of the unit. (Range: 1 - 6)
console(config)# stack reload unit 2