Allied Telesis AT-S95 CLI - Manual (Page 218)

Page 218
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Chapter 24.Radius Commands
radius-server host
The radius-server host Global Configuration mode command specifies a RADIUS server host. Use the no form
of this command to delete the specified RADIUS host.
Syntax
radius-server host {ipv4-address | ipv6-address | hostname} [auth-port auth-port-number] [timeout timeout]
[retransmit retries] [deadtime deadtime] [key key-string] [source ipv4-source | ipv6-source] [priority priority]
[usage type]
no radius-server host {ipv4-address | ipv6-address | hostname}
Parameters
•
ipv4-address — IPv4 address of the RADIUS server host.
• ipv6-address — IPv6 address of the RADIUS server host.
• hostname — Hostname of the RADIUS server host. (Range: 1 - 158 characters)
• auth-port-number — Port number for authentication requests. The host is not used for authentication if the
port number is set to 0. (Range: 0 - 65535)
• timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
• retries — Specifies the retransmit value. (Range: 1 - 10)
• deadtime — Length of time in minutes during which a RADIUS server is skipped over by transaction
requests. (Range: 0 - 2000)
• key-string — Specifies the authentication and encryption key for all RADIUS communications between the
device and the RADIUS server. This key must match the encryption used on the RADIUS daemon. To specify
an empty string, enter "". (Range: 0 - 128 characters)
• ipv4-source — Specifies the source IPv4 address to use for communication. 0.0.0.0 is interpreted as request
to use the IP address of the outgoing IP interface.
• ipv6-source — Specifies the source IPv6 address to use for communication. 0.0.0.0 is interpreted as request
to use the IP address of the outgoing IP interface
• priority — Determines the order in which servers are used, where 0 has the highest priority. (Range: 0 -
65535)
• type — Specifies the usage type of the server. Possible values: login, dot.1x or all.
Default Configuration
No RADIUS server host is specified.
The port number for authentication requests is 1812.
The usage type is all.
Command Mode
Global Configuration mode