Allied Telesis AT-S95 CLI - Manual (Page 106)

Page 106
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Example
In the following example, automatic crossover is enabled on port 1/e5.
back-pressure
The back-pressure Interface Configuration (Ethernet, port-channel) mode command enables back pressure on a
given interface. Use the no form of this command to disable back pressure.
Syntax
back-pressure
no back-pressure
Parameters
This command has no arguments or keywords.
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example back pressure is enabled on port 1/e5.
system flowcontrol
Use system flowcontrol Global Configuration mode to enable flow control on cascade ports. Use the no form of
this command to disable it.
Syntax
system flowcontrol
no system flowcontrol
Parameters
This command has no arguments or keywords.
console(config)# interface ethernet 1/e5
console(config-if)# mdix auto
console(config)# interface ethernet 1/e5
console(config-if)# back-pressure