Allied Telesis AT-S95 CLI - Manual (Page 24)

Page 24
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Chapter 2. ACL Commands
ip access-list
The ip access-list Global Configuration mode command defines an IPv4 Access List and places the device in
IPv4 Access List Configuration mode. Use the no form of this command to remove the Access List.
Syntax
ip access-list access-list-name
no ip access-list access-list-name
Parameters
•
access-list-name — Name of the IPv4 Access List. (Range: 1 - 32 characters)
Default Configuration
No IPv4 Access List is defined
Command Mode
Global Configuration mode
User Guidelines
IPv4 ACLs are defined by a unique name. An IPv4 ACL and MAC ACL cannot share the same name.
Example
The following example places the device in IPv4 Access List Configuration mode.
permit (ip)
The permit IP Access-list Configuration mode command sets conditions to allow a packet to pass a named IP
Access List.
Syntax
permit {any | protocol} {any | {source source-wildcard}} {any | {destination destination-wildcard}} [dscp number |
ip-precedence number] [fragments]
permit-icmp {any | {source source-wildcard}} {any | {destination destination-wildcard}} {any | icmp-type} {any |
icmp-code} [dscp number | ip-precedence number]
permit-igmp {any | {source source-wildcard}} {any | {destination destination-wildcard}} {any | igmp-type} [dscp
number | ip-precedence number]
permit-tcp {any | {source source-wildcard}} {any | source-port} {any |{destination destination-wildcard}} {any |
destination-port} [dscp number | ip-precedence number] [flags list-of-flags]
console(config)# ip access-list