Allied Telesis AT-S95 CLI - Manual (Page 215)

QoS Commands
Page 215
Parameters
•
dscp-list — Specifies up to 8 DSCP values separated by a space. (Range: 0 - 63)
• queue-id — Specifies the queue number to which the DSCP values are mapped. (Range: 1 - 4
Default Configuration
The following table describes the default map.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example maps DSCP values 33, 40 and 41 to queue 1.
qos cos
The qos cos Interface Configuration (Ethernet, port-channel) mode command defines the default CoS value of a
port. Use the no form of this command to return to the default configuration.
Syntax
qos cos default-cos
no qos cos
Parameters
•
default-cos — Specifies the default CoS value of the port. (Range: 0 - 7)
Default Configuration
Default CoS value of a port is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
DSCP value Queue-ID
00-15 1
16-31 2
32-47 3
48-63 4
console(config)# qos map dscp-queue 33 40 41 to 1