Allied Telesis AT-S95 CLI - Manual (Page 384)

Page 384
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Parameters
•
sec — Specify the timeout in seconds. (Range: 30 – 180)
Default Configuration
The guest VLAN is applied immediately.
Command Mode
Global Configuration mode.
User Guidelines
This command is relevant if the guest VLAN is enabled on the port. Configuring the timeout adds delay from
enabling 802.1X (or port up) to the time the switch puts the port in the guest VLAN
Example
The following example configures the delay from enabling 802.1X (or port up) to adding the port to the guest VLAN
to 50 seconds.
dot1x single-host-violation
The dot1x single-host-violation Interface Configuration (Ethernet) mode command configures the action to be
taken, when a station whose MAC address is not the supplicant MAC address, attempts to access the interface.
Use the no form of this command to restore defaults.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown} [trap seconds]
no port dot1x single-host-violation
Parameters
•
forward — Forwards frames with source addresses that are not the supplicant address, but does not learn
the source addresses.
• discard — Discards frames with source addresses that are not the supplicant address.
• discard-shutdown — Discards frames with source addresses that are not the supplicant address. The port
is also shut down.
• trap seconds— Indicates that SNMP traps are sent. Specifies the minimum amount of time in seconds
between consecutive traps. (Range: 1- 1000000)
Default Configuration
Frames with source addresses that are not the supplicant address are discarded. No traps are sent.
Command Mode
Interface Configuration (Ethernet) mode
console# configure
console(config)# dot1x guest-vlan timeout 50