Allied Telesis AT-S95 CLI - Manual (Page 190)

Page 190
Allied Telesis
AT-S95 Management Software CLI User’s Guide
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the
appropriate interface.
The system supports up to 128 management access rules.
Example
The following example permits all ports in the mlist Access List.
deny (Management)
The deny Management Access-List Configuration mode command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel port-channel-number] [service service]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel
port-channel-number] [service service]
Parameters
•
interface-number — A valid Ethernet port number.
• vlan-id — A valid VLAN number.
• port-channel-number — A valid port-channel number.
• ip-address — A valid source IP address.
• mask — A valid network mask of the source IP address.
• mask prefix-length — Specifies the number of bits that comprise the source IP address prefix. The prefix
length must be preceded by a forward slash (/). (Range: 0 - 32)
• service — Service type. Possible values: telnet, ssh, http, https and snmp.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the
appropriate interface.
The system supports up to 128 management access rules.
console(config)# management access-list mlist
console(config-macl)# permit